Technical Information For Easysense Q; System Menu; Selecting The Sensor Range; Factory Reset - Data Harvest EasySense Q 3 Manual

Technical Information for EasySense Q

System Menu

A system menu is accessed from the main menu. This will allow you to change the range
of a sensor, apply a factory reset and check the battery condition. To prevent accidental
change this menu can only be accessed if the user holds down both the red square and
yellow arrow buttons for 2 seconds.

Selecting the sensor range

The internal light sensor in EasySense Q and some plug-in Smart Q Sensors have more
than one range. The range can be altered either on EasySense Q (see below) or on the
computer by using the Sensor Configuration application in the Sensing Science program.
Once selected EasySense Q will use this range or units (until they are reselected).
Whilst in the main menu hold down the red square (stop) button and
then the yellow arrow (scroll) button and keep them both held down
for 2 seconds. The display will alter to show the System menu i.e.
Battery Level, Set Sensor Range and Factory reset.
Use the yellow arrow
Press the green triangle button
cursor until it is pointing to the relevant sensor i.e. the internal light sensor or the
Smart Q Sensor connected to external 1A or 2B. Press the green triangle (enter)
select. An asterisk (*) will indicate the currently selected range. Use the yellow arrow
to scroll the cursor down until it is pointing at the required range. Press the green triangle
(enter) to select. The asterisk will move to indicate the selected range.
Press the red square (stop)
to the main menu.

Factory Reset

To reset EasySense Q back to its factory default condition i.e. clear all memory (all
stored data sets will be deleted) and set the built-in light level sensor range to the 0 –
1000 lux range.
Whilst in the main menu hold down the red square (stop) button and
then the yellow arrow (scroll) button and keep them both held down
for 2 seconds. The display will alter to show the System menu i.e.
Battery Level, Set Sensor Range and Factory reset.
Use the yellow arrow
reset'. Press the green triangle (enter)
A check message will warn that this reset will delete all data sets - press the green
triangle (enter) to confirm your choice or press the red square (stop)
A message will confirm if the reset has been done, press the green triangle
to the main menu.
to scroll the cursor until it is pointing at 'Set Sensor Range'.
to select. Use the yellow arrow
to return to the system menu and then again
button to scroll the cursor down until it is pointing at 'Factory
to select.
13
button to scroll the
to
to return
to cancel.
to return