Mayr EAS-compact 493. 4 .0 Series Installation And Operating Instructions

Installation and Operating Instructions for
®
EAS -compact
Please read and observe this Operating Instruction carefully.
A possible malfunction or failure of the clutch and any damage may be caused by not observing it.
Table of contents:
Page 1: - Table of contents
- Manufacturer's declaration
- Safety regulations
Page 2: - Clutch view
- Parts list
Page 3: - Design
- Supply condition
- Function
- Important mounting instructions
- Assembly
- Table 1: Screw tightening torques
- Assembly of the limit switch
Manufacturer's declaration
The product is a component within the scope of the Machinery directive 98/37/EC for installation into machines or equipment.
An initial start-up is prohibited until it has been noticed that the machinery or the equipment into which this product has been incorporated
correspond to the EC-guidelines.
Safety regulations
The submitted installation and operating instructions (E+B) is part of the clutch shipment.
Keep the E+B always well accessible near the clutch.
Danger!
If the EAS
If the relevant standards of the safety or installation conditions are not observed.
Necessary protective measures to be undertaken by the user
Cover all moving parts for protection against squeezing, seizing, dust deposit and hit of foreign objects.
The clutches must not be put into operation without limit switch, unless with mayr
Only qualified and well-trained specialists should work on the units to avoid any personal injury or damage to
machinery under observance of the valid standards and guidelines. The installation and operating instructions
are to be read carefully before installation and operation
Attention:
Based on the guideline 94/9/EC (ATEX-guideline) this product is not suitable for the application in potential explosive areas without
evaluation of the conformity.
10/03/2005 K/TK/Kr
Page 1 of 5
®
clutch Type 493._ 4 _ .0
®
-clutches have been modified or reconverted.
With these safety notes no claim on completeness is raised!
Chr. Mayr GmbH + Co. KG
Eichenstraße 1
87665 Mauerstetten
Germany
Sizes 01 – 1
Page 4: - Torque adjustment (at the factory)
- Adjusting the torque
Page 5: - Permissible shaft misalignments
- Table 2: Misalignment values
- Alignment of the coupling
- Maintenance
- Disposal
Tel.: 08341 / 804-0
Fax: 08341 / 804-421
http://www.mayr.de
eMail: info@mayr.de
(B.4.16.GB)
®
not otherwise agreed.