Advertisement
BEFORE YOU BEGIN
Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there
should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY
OR MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 5 for charging information)
3.
Charger
(Note: Charger design may
vary from one shown)
Charger
Charger
Plug
Port
Spark Bar
Spark Cartridge
Motor
Required Tools
5mm Allen Wrench
8mm/10mm/13mm and
(Included)
16mm Open Wrenches
3mm Allen Wrench
(Not Included)
Twist Grip
Throttle
1. Handlebar
Stem
Collar Clamp
On/Off Switch
Reset Button
- Battery
- Control Module
2. Battery Tray
Screwdriver
(Not Included)
(Not Included)
Bicycle-style tire pump for
Phillips
schrader valve tires with
pressure gauge
(Not Included)
3
WARNING:
DO NOT USE NON-
RAZOR PARTS WITH
YOUR RAZOR ELECTRIC
SCOOTER.
The scooter has been built
to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the
frame, fork and all other parts.
Certain aftermarket parts may
not be compatible and will void
the warranty.
Brake Lever
Note: Electric scooter must
be moving at 3 mph/5 kmh
while applying the throttle
to engage motor.
Product ID Locations:
See locations to the left
1. Handlebar Stem
2. Battery Tray
3. Charger
Limiter
4. UPC Side of Box (not shown)
Advertisement
