Page 1
™ NOTE: The eSpark must be traveling up to 3mph before motor will engage. Kick start up to 3mph while twisting the throttle to engage motor. Owner’s Manual Read and understand this entire manual before riding! DO NOT RETURN TO STORE! NOTE: Manual illustrations are for demonstration purposes only.
RIDINg PRaCTICES aND CONDITIONS Always check and obey any local laws or regulations which may • Never use your scooter to try to start a fire. Your eSpark™ scooter emits affect the locations where the electric scooter may be used.
(lace-up shoes with rubber soles), never ride barefooted or in sandals, and local laws and regulations to see where and how you may use your Razor keep shoelaces tied and out of the way of the wheels, motor and drive scooter legally.
(Not Included) with pressure gauge (Not included) Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.
aSSEMBLy aND SET-UP q attaching the Handlebars Note: Make sure the cables/ wires are out of the way before inserting the stem into the fork. Open the quick release. Depress the push button (a) Adjust the tension of the located on the front fork and quick release to where you can insert the handlebar stem until close the lever all the way to...
aSSEMBLy aND SET-UP q Installing Spark Bar Using two (2) 5mm Allen Re-insert the coupling bolt wrenches remove the coupling through the metal bar and bolt that is attached to the end tighten until Spark bar is locked of the metal bar of the Spark securely in place.
8-2 - Lock washer 8-1 - 17mm locknut Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.
Page 8
REPaIR aND MaINTENaNCE q Chain and Rear Wheel Replacement Note: Rear wheel hardware Tools required: Phillips screwdriver, 10mm open wrench, two (2) 8mm open wrenches, and two (2) 13mm sequence open wrenches. 18-1 18-2 18-4 18-3 18-6 18-7 18-8 18-5 18-4 18-3 18-2...
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED. Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak. Do not dispose of a lead-acid battery in your regular household trash.
Even with proper care, a rechargeable battery does not last forever. full charge Average battery life is 1 to 2 years depending on scooter use and conditions. Replace only with a Razor replacement battery. Brakes are not adjusted properly Refer to adjusting the brakes instructions on page 6.
Loose wires or connectors doesn’t run, but other they are tight. times it does Motor or electrical switch Contact your local Razor authorized service center for diagnosis and damage repair. Scooter makes loud Chain is too dry Apply a lubricant such as 3 in 1 or Tri-Flow to the chain.
Page 12
PaRTS Keep your scooter running for years with genuine Razor parts. Visit our website for more information on spare part availability. (Specifications subject to change without notice.) Reset button Handlebar grip (right/left) Control module Single speed twist grip throttle Battery (2- 12V/ 4.5Ah)
Page 13
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.