Medela Invia Liberty Series Quick Card

Invia Liberty
®
Quick Card – Clinician
The Invia Liberty Quick Card does not replace the Invia Liberty instructions for use. For information concerning
intended use, indications, contraindications, warnings and cautions please refer to the Invia Liberty Clinician instructions
for use Ref 201.0395 available with the Invia Liberty pump or on the Medela website.
Preparation for use
1. Attach Invia Liberty canister
tubing to the pump.
New patient therapy set up
1. Switch pump ON in Administra-
tive mode, press and hold [
and then press [ ].
Basic operating commands
On/Off
1. Switch pump ON.
2. Switch pump OFF, press and
hold for 3 seconds.
Change pressure level – Standard
1. Enter Administrative mode,
press and hold [ ], and then
press [ ].
™
2. Click Invia Liberty canister into
place.
2. Acknowledge disclaimer,
], confirm with "OK".
Administrative mode
1. Enter Administrative mode,
press and hold [ ], and then
press [ ].
2. Press selection buttons up or
down to set pressure level from
preset menu. For pressure level
outside preset values, refer to
the instructions for use –
Chapter 'Change pressure set-
up mode'.
3. Connect canister tubing to the
dressing tubing.
3. Choose "Yes" to set new
therapy number or "No" to keep
same therapy number.
Choose settings
1. Enter settings menu in Admin-
istrative mode, press and hold
simultaneously.
2. Use selection buttons up or
down to navigate.
3. Press "OK" to confirm and enter
main display.
4. Charge battery for the first
time before starting therapy.
When completely discharged,
approximate charging time
is 4 hours. Recharge battery
throughout the length of thera-
py. The expected battery time
generally exceeds 14 hours.
4. Press selection buttons up or
down to set pressure level.
5. Press "OK" to confirm and enter
main display.
Enter/exit standby
1. Press "Standby" to enter
standby mode.
2. Press "ON" to resume therapy.
1