Subscribe to Our Youtube Channel
Related Manuals for Burkert 6026
Summary of Contents for Burkert 6026
- Page 1 Type 6026 2/2-way valve 2/2-Wege-Ventil Vanne 2/2 voies Operating Instructions Bedienungsanleitung Manuel d‘utilisation...
-
Page 2: Intended Use
The device is designed for blocking, dosing, filling and ventilating users. gaseous and liquid media. ▶ The liability and warranty for the Type 6026 device will be invali- ▶ When using the device, observe the authorised data, operating dated if the operating instructions are not followed. -
Page 3: Basic Safety Instructions
Isolation Risk of injury due to electric shock. The device must not be isolated more than ▶ Before reaching into the device or the system, switch off the power 2 cm from the body edge upwards to the supply and secure to prevent reactivation! Observe the applicable accident prevention and safety regulations for electrical devices. -
Page 4: Technical Data
▶ In the case of alternating voltage, pay attention to movable Conformity core. ▶ Check media resistance. The Type 6026 conforms to the EU directives as per the EU Declaration of Conformity (if applicable). General hazardous situations. To prevent injuries, ensure that: Standards ▶... -
Page 5: Electrical Operating Conditions
Media neutral gaseous and liquid media that do not attack the body and seal materials (see resis- Intermittent operation characteristics for variant tance table: www.burkert.com). Check resis- Ambient temperature [°C] with AC/DC high-perfor- tance in each individual case. mance electronics... -
Page 6: Mechanical Data
Electrical data Mechanical data Connections DIN EN 175301-803 Form A: Port connections G¼, G½, G⅜ for cable plug Type 2508 Operating voltage see type label Materials Body: Voltage tolerance ±10 % Identification MS Brass body, valve seat 1.4305 Nominal power 8 W operation, 85 W inrush brass body, brass valve seat Switching frequency max. -
Page 7: Type Label (Example)
Intermittent operation for variant with AC/DC high-performance Type label (example) electronics Seat orifice Seal material Characteristics (acc. to DIN VDE 0580) Circuit function Body material cycle time Type – duty cycle – Connection, currentless break – pressure range relative duty ED –... -
Page 8: Fluid Installation
INSTALLATION Fluid installation Installation position: any, preferably coil or actuator face up. DANGER! → Clean pipelines and flange connections. Risk of injury from high pressure in the system. → Install dirt trap at the valve inlet (0.2...0.4 mm). ▶ Before loosening lines and valves, turn off the pressure and Note the flow direction of the valve. -
Page 9: Electrical Installation
Electrical installation Only for variant with terminal connection box: • Connect a maximum of one conductor per terminal point WARNING! • The maximum connection cable cross-section is 2.5 mm² / AWG 14 Risk of injury due to electric shock. • Remove insulation on the wires to a maximum length of 6 mm ▶... -
Page 10: Maintenance & Troubleshooting
MAINTENANCE, TROUBLESHOOTING Rotating the solenoid WARNING! WARNING! Risk of injury due to electric shock. Risk of injury due to improper maintenance work. ▶ Maintenance may be carried out by authorised technicians only If there is no protective conductor function between the coil and and with the appropriate tools. -
Page 11: Transportation, Storage, Disposal
DISASSEMBLY TRANSPORTATION, STORAGE, DISPOSAL DANGER! NOTE! Risk of injury from high pressure in the system. Transport damage. ▶ Before loosening lines and valves, turn off the pressure and drain the lines! Inadequately protected devices may be damaged during Risk of injury due to electric shock. transport. - Page 12 Manuals and data sheets on the Internet: www.burkert.com Bedienungsanleitungen und Datenblätter im Internet: www.buerkert.de Instructions de service et fiches techniques sur Internet : www.burkert.fr © Bürkert Werke GmbH & Co. KG, 2019 Operating Instructions 1907/00_EU-ML_00815315 / Original DE www.burkert.com...
Need help?
Do you have a question about the 6026 and is the answer not in the manual?
Questions and answers