OPERATING INSTRUCTIONS INTENDED USE The operating instructions contain important information. Incorrect use of the solenoid valve Type 6027 can be dangerous to ▶ Read the operating instructions carefully and follow the safety instruc- people, nearby equipment and the environment. ▶ The device is designed to control, shut off and meter neutral media tions in particular, and also observe the operating conditions.
BASIC SAFETY INSTRUCTIONS Risk of short-circuit/escape of media through leaking screw joints. ▶ Ensure seals are seated correctly. These safety instructions do not make allowance for any contingencies ▶ Carefully screw valve and connection lines together. and events which may arise during installation, operation and maintenance. Danger –...
3.2 Information on the internet • Voltage (Tolerance ± 10 %) / Current type The operating instructions and data sheets for type 6027 can be found • Coil power consumption (active power in W - at operating on the internet at: temp.)
4.2 Application conditions Permitted medium temperature and ambient temperature depending on sealing material: Ambient temperature: max. +55 °C Permitted medium temperature depending on coil material and sealing Temperatures for valves with UL/UR approval material: seal material Variant Coil material Seal material Medium temperatur EPDM (AA) Standard...
Check resistance in individual cases (www.burkert.com) Orifice seal material 4.3 Conformity Circuit function In accordance with the EC Declaration of conformity, Type 6027 is com- Body material Type pliant with the EC Directives. 4.4 Standards 6027 A 6,0 FKM...
INSTALLATION 5.2 Before installation Installation position: any, actuator preferably upwards. Safety instructions DANGER! Procedure: → Check pipelines for dirt and clean. Risk of injury from high pressure in the equipment. → Install a dirt filter before the valve inlet (≤ 0.3 mm). ▶...
Page 8
5.3 Installation – body variant 5.5 Electrical connection of the cable plug Procedure: WARNING! → Hold the device with a open-end wrench on the body and screw into Risk of injury due to electrical shock. the pipeline. ▶ Before reaching into the system, switch off the power supply and secure to prevent reactivation.
Page 9
→ Tighten cable plug (for permitted types see data sheet), observing max. torque 50-60 Ncm. → Check that seal is fitted correctly. → Connect protective conductor and check electrical continuity. 5.6 Installation of coil 4 x 90° WARNING! Risk of escape of media. O-Ring When a sticking nut is loosened, medium may escape.
MAINTENANCE, TROUBLESHOOTING If the magnet is not attracting Possible causes: Safety instructions • Short circuit or coil interrupted, WARNING! • core or core area dirty. Risk of injury from improper maintenance. ▶ Maintenance may be carried out by authorised technicians only and with the appropriate tools.
TRANSPORT, STORAGE, DISPOSAL SPARE PARTS NOTE! CAUTION! Transport damages. Risk of injury and/or damage by the use of incorrect parts. Inadequately protected equipment may be damaged during transport. Incorrect accessories and unsuitable spare parts may cause injuries and • During transportation protect the device against wet and dirt in damage the device and the surrounding area.
Need help?
Do you have a question about the 6027 and is the answer not in the manual?
Questions and answers