Advertisement
Quick Links
Sr600
In-Car Video Camera
and Windshield Mount
Camera Base
Installation
Guide
MN004494A01-A
For Quick Start Guide visit
https://learning.motorolasolutions.com
1. Inbox Content
1.1 Sr600 In-Car Video Camera
Part KT000262A01
®
1.4 RAM Adhesive Mount
Part HW001632A01
2. Configure Sr600 In-Car Video Camera for Use
2.1 Welcome! Please begin by referring to your Motorola
CommandCentral Admin documentation to access the software
to register your camera.
1.2 Windshield Mount Camera Base
Part HW001631A01
1.5
Collar Locking Screw
Part 08-04-02-538LF
2.2 Press and hold the Power/Record button to turn on the
camera and wait about 30 seconds. The camera will vibrate
and the blinking blue LED will appear.
1.3 16-Pin Cable
Part CB000668A01
1.5 Latch Locking Screw
Part 08-04-02-540LF
Advertisement
Related Manuals for Motorola Sr600
Summary of Contents for Motorola Sr600
- Page 1 Part HW001632A01 Part 08-04-02-538LF Part 08-04-02-540LF Camera Base 2. Configure Sr600 In-Car Video Camera for Use Installation 2.1 Welcome! Please begin by referring to your Motorola 2.2 Press and hold the Power/Record button to turn on the CommandCentral Admin documentation to access the software camera and wait about 30 seconds.
- Page 2 2.5 Make sure the camera is in range of the Wi-Fi network should now be blinking red, green and blue: scan it with the Sr600 within five minutes. You must generate a specified by CommandCentral Admin. Hold the camera still.
- Page 3 3. Sr600 In-Car Video Camera and Base Connector Interface 4. Sr600 Camera and Base Installation 3.1 Windshield mount camera base - 16-PIN Automotive 3.2 Sr600 In-Car Video Camera - 6-PIN Interface Connector + 4.1 Peel off one side of adhesive disc (either side). Carefully ®...
- Page 4 4. Sr600 In-Car Video Camera and Base Installation 4.5 Your Sr600 In-Car Video Camera will record a 360° 4.6 With the Sr600 In-Car Video Camera snapped into its base 4.7 Once the location of the assembly is satisfactory, mark the ®...
-
Page 5: Wiring Diagram
5. Wiring Diagram 6. Installing the Sr600 In-Car Video Camera 5.1 Now it’s time to route the cable assembly to the vehicle 6.1 After routing the wire harness to the junction box, ensure 6.2 Attach the camera base into the RAM® Mount installed on junction box and connect the wires per the wiring diagram. - Page 6 In this case additional wire (not supplied) may be required to connect the trigger lines on the Sr600 cable kit to the required triggers in the vehicle. Multi-conductor wire of at least 22 gauge may be used to make these connections.