Removing the optical-drive connector board
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
optical drive
(optional).
2. Remove the
base
cover.
Procedure
NOTE:
Applicable only for computers that are shipped with optical drive.
1. Lift the latch and disconnect the optical-drive connector-board cable from the system board.
2. Remove the screw (M2x2) that secures the optical-drive connector board to the palm rest and keyboard assembly.
3. Lift the optical-drive connector board along with the cable off the palm rest and keyboard assembly.
28
Removing the optical-drive connector board
computer. After working inside your computer, follow the instructions in
13
After