Table of Contents
Advertisement
General
Information
Thank you for purchasing your
Hydromatic
®
pump. To help
ensure years of trouble-free
operation,
please
following manual carefully.
Before Operation:
Read the following instructions
carefully. Reasonable care and
safe methods should be practiced.
Check
local
codes
requirements before installation.
Attention:
This manual contains important
information for the safe use of
this product.
Read this manual
completely before using this
product and refer to it often for
continued
safe
product
DO NOT THROW AWAY OR
LOSE THIS MANUAL. Keep it
in a safe place so that you may
refer to it often.
WARNING: Before handling
these pumps and controls,
always disconnect the power
first. Do not smoke or use
sparkable electrical devices or
flames in a septic (gaseous) or
possible septic sump.
Pump
Warning
To reduce risk of electrical shock:
1. Risk of Electrical Shock:
This pump has not been
investigated
for
swimming pool areas.
2
2. Risk of Electrical Shock:
Connect only to a properly
grounded receptacle.
Septic tank is to be vented
in accordance with local
plumbing codes.
Do not smoke or use sparkable
electrical devices or flame in a
read
the
septic (gaseous) or possible
septic sump.
If a septic sump condition
exists and if entry into sump is
necessary, then (1) provide
proper safety precautions per
OSHA requirements and (2)
and
do not enter sump until
these precautions are strictly
adhered to.
Do not install pump in location
classified as hazardous per
N.E.C., ANSI/NFPA 70- 2001.
Failure to heed above cautions
could result in injury or death.
use.
Pump
Installation
These
must be followed for satisfactory
performance of your pump:
1. Provide proper sump (minimum
sump diameter of 18").
2. Do not set pump directly on
the bottom of sump pit if it is
not solid. Raise the pump by
using bricks or concrete blocks
underneath it.
3. Make sure sump is free of
string, cloth, nails, gravel, etc.,
before installing pump.
4. Risk of electrical shock–connect
only to a properly grounded,
grounding-type receptacle.
5. Do not remove ground pin
from electrical plug.
6. Do not use an extension cord.
use
in
important
instructions
7. For proper automatic operation,
make sure the pump power
cord is plugged into the
piggyback receptacle on the
diaphragm switch cord.
Do not cut, crimp, or bend
switch power cord. The vent
tube needs to "breathe" for
proper operation of switch.
This may cause pump failure
and void warranty.
8. Connect to separate electrical
circuit taken directly from
main switch.
9. Use steel or plastic pipe for all
connecting
lines
pump and sewer outlet.
Note: Some city regulations
do not allow installing a
pump with plastic pipe. Check
local regulations.
10.In applications where the
pump may sit idle for months
at a time, it is recommended
that the pump(s) be cycled
every month to ensure the
pumping system is working
properly when needed.
11. Hydromatic
check
should
be
installed
discharge pipe.
12.The Hydromatic Q Alert is an
audible
alarm
for high water conditions. It
should be installed in every
pump pit for greater protection.
Note: Q Alert is for indoor
use only. Other Q Alarm and
control panels are available
for outdoor use. Contact your
Hydromatic
distributor
applications.
between
valve
in
system
for
Advertisement
Table of Contents
