Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Pentair Pool Products Hydromatic S4HRC
Summary of Contents for Pentair Pool Products Hydromatic S4HRC
- Page 1 Pump Installation and Service Manual S4HRC Submersible Sewage Pump Recessed Impeller For use with product built with USEM motor. NOTE! To the installer: Please make sure you provide this manual to the owner of the pumping equipment or to the responsible party who maintains the system.
-
Page 2: General Information
must have impellers manually green wire is connected to a good General rotated (6 revolutions) after ground such as water pipe or Information setting non-operational for 3 ground stake. The auxiliary cable months or longer and prior to for seal failure and heat sensors is electrical start-up. - Page 3 set at turn-on for one pump, and Alarm Controls: improper components or if the one set for turn-on for two pumps. heat sensors are not properly The alarm level is usually set Pumps alternate operation on each connected the motor guarantee above the override level so successive cycle.
-
Page 4: Installation Instructions
amps on the motor housing. The check valve the line pressure can always be submerged during the amp draw on these submersible be cut off. Single pump systems pumping cycle. The second motors is slightly higher than are sometimes installed without a or turn-on control is set about corresponding horsepower... - Page 5 Making Electrical Conections: IMPORTANT: If the equipment If seal failure unit is used, is not properly wired and connect as shown with seal All electrical wiring must be in protected as recommended, the failure system. If seal failure unit accordance with local code, and motor guarantee is void.
-
Page 6: Pump Operation
somewhat higher, 5 to 10%, WARNING: Before handling Pump without causing trouble. For these pumps and controls, Operation excessive amp draw on one always disconnect the power leg, the power company should first. be consulted. Do not smoke or use sparkable Starting System: electrical devices or flames in a Pump... - Page 7 connecting wire must be 9. Check top bearing. If clean and high voltage ground test on disconnected before housing does not turn rough, bearings each wire. The only wire that is completely removed. See can be reused and it is not should show ground is the sectional drawing.
- Page 8 bolts in back of holes, pry bearing supply house Pump plates loose. This will force can be obtained from the Maintenance out the lower seal if not Hydromatic factory. already removed. 12.IMPORTANT: Do not use 9. Remove snap ring that holds any of the old seal parts.
- Page 9 2. To check for defective float Motor stops and then restarts Pump control, put selector switch in after short period, but overload Maintenance Auto position and turn off heaters in starter do not trip. main power. Put a jump wire 1.
-
Page 10: Parts List
S4HRC Parts List ORDERING REPLACEMENT PARTS: Product improvements are made from time to time. The latest part design will be furnished as long as it is interchangeable with the old part.When ordering replacement parts, always furnish the following information: (1) pump serial number, (2) pump model and size, (3) part description, (4) part number, (5) impeller diameter (if ordering impeller), (6) quantity required, and (7) shipping instructions. - Page 11 S4HRC...
-
Page 12: Warranty
WARRANTY Hydromatic ® warrants to the original purchaser of each Hydromatic product(s) that any part thereof that proves to be defective in material or workmanship within one year from date of installation or 18 months from manufacture date, whichever comes first, will be replaced at no charge with a new or remanufactured part, F.O.B.
Need help?
Do you have a question about the Hydromatic S4HRC and is the answer not in the manual?
Questions and answers