Table of Contents
Advertisement
BAQ kaloMAX NT II
The pre-pressure for pneumatic dosage can be adjusted by using the rotary knob on
the back of the device. The setting is shown on the upper left part of the main screen.
5.2.1
Input range
Speed
Distance
Grinding ball diameter
5.3
Start / Stop
Press START on the main screen to start the grinding process.
A small amount of grinding suspension is put on the grinding ball, i.e. the valve opens
for the defined dosage time.
After a pause of 1.5 seconds, the motor starts.
The grinding process can be aborted anytime by pressing the STOP button. The
grinding process ends after the grinding path has been covered or the number of
revolutions has been completed.
Ball revolutions
Grinding speed
Shaft revolutions
Number of ball revolutions
Grinding path
Number of shaft revolutions
Minimum
Maximum
15 /1/min
1.4 /m/min
30 /1/min
13 /U
B
1.2 /m
20 /U
S
12 /mm
Manual
590 /1/min
55.8 /m/min
1000 /1/min
9200 /U
B
870 /m
15000 /U
S
40 /mm
Page 18
Advertisement
Table of Contents
