Table of Contents
Advertisement
BAQ kaloMAX NT II
5.1.4
Input of numerical values
Open the number input screen to enter numerical values. In the field highlighted in
white the entered number is displayed. The ◄ and ► cursor keys are used to shift the
cursor in the field. F2 (←) deletes the character left of the cursor. Numerical values and
the decimal separator are entered by using the appropriate keys.
F4 (OK) or ENTER key completes the input and saves the value.
F3 (Cancel) or ESC aborts the input.
5.2
Grinding parameters
The following parameters have to be defined for the grinding process:
Grinding speed (m/min), ball RPM or shaft RPM
•
Grinding path (m), number of ball revolutions or number of shaft revolutions
•
Dosage time of the abrasive slurry (ms)
•
Diameter of the grinding ball
•
Furthermore, the following basic settings can be made:
Unit in which speed has to be entered (grinding speed, ball revolutions per minute
•
or shaft revolutions per minute)
Unit in which the grinding path has to be entered (meter, number of ball
•
revolutions or number of shaft revolutions)
These parameters (with basic settings) can be saved and retrieved at a later point of
time. The current parameters can be changed in the main screen (see chapter5.4) or
via the menu (see chapter 5.6.1); stored parameters have to be loaded first, before
they can be altered and stored again.
The configuration serves to define the basic settings (see chapter 5.8.1).
Manual
Page 17
Advertisement
Table of Contents
