Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Intellisystem IT50W
Summary of Contents for Intellisystem IT50W
- Page 1 Network Camera IT50W Quick Installation Guide This guide describes the basic functions of IT50W Network Camera. All detailed information is described in the user's manual. Intellisystem Technologies - http://www.intellisystem.it...
- Page 2 IT50W Quick Start Guide Warning Before Install Power off the Network Camera Keep the Network Camera as soon as it is found away from the water. If the smoking or smelt unusual. Network Camera is wet, power off immediately. Contact your distributor when such Contact your distributor when such cases happen.
- Page 3 IT50W Quick Start Guide Do not place the Network Do not touch the Network Camera on unsteady Camera when it's lightening. surfaces. Do not disassemble the Do not drop the Network Network Camera. Camera. Do not insert any object into the Network Camera, such as needles.
-
Page 4: Check Package Contents
IT50W Quick Start Guide Check package contents IT50W Power adapter Camera stand Antenna Software CD Intellisystem Technologies - http://www.intellisystem.it... -
Page 5: Physical Description
IT50W Quick Start Guide Physical description Front panel Antenna Microphone Lens and manual focus ring Status LEDs Rear panel Network Camera Note the serial number from the label on the unit. Model IT50W This serial number is the same as the Ethernet... - Page 6 IT50W Quick Start Guide Install your Network Camera in Ethernet network 2. Connect power cord to a power outlet. 1.Use Ethernet cable to make connection from Ethernet port to the hub. Use Category 5 Cross Cable when the Network Camera is directly connected to PC.
-
Page 7: Assign Ip Address
IT50W Quick Start Guide Assign IP address 1.Run the IP Installer under the Software Utility directory from software 2.Click on serial number that matches the one you just note. 3.Assign a free IP address. 4.If you want to x the IP address of the unit, check option “Use... - Page 8 1.SSID abbreviated from Service Set Identi er is the name assigned to the wireless network. The IT50W's factory SSID setting is set to "default". 2.Select "Ad-Hoc" wireless mode if you want the IT50W to communicate without using an AP or wireless router.
Need help?
Do you have a question about the IT50W and is the answer not in the manual?
Questions and answers