Thread Catcher Carrier Position - Pfaff 571 Adjustment Manual

13

Thread catcher carrier position

.06.02
Requirement
1. There should be a minimum amount of play between the pinion 3 and the toothed
segment 4.
2. The clearance between the toothed segment 4 and the outer edge of the thread
catcher carrier 1 should be the same size (see arrow) in both the neutral position and
the front turning point position of the catcher.
1
Fig. 13 - 39
 Adjust the thread catcher carrier 1 (screws 2) according to the ruled.
4
If rule 2 is not achieved, loosen the screw 2 and move the toothed segment 4
by one tooth.
3
1
2
4
Adjustment
1
4
2
45