13
Roller presser
.04.19
Rule
If the roller presser 1 is fi tted to the feed wheel 5, it should
1. be parallel to the feed wheel 5 looking in the sewing direction,
2. be positioned at the centre of the needle (the left needle on the PFAFF 574) looking in
the sewing direction,
3. be positioned as close as possible to the needle (the left needle on the PFAFF 574)
looking crossways to the sewing direction.
1
Fig. 13 - 19
Raise the roller presser 1.
Always observe rule 1 with the following adjustments.
Adjust the roller presser 1 (screw 2) according to rule 2.
Rest the roller presser 1 on the feed wheel 5.
Adjust the roller presser bracket 3 (screw 4) according to rule 3.
4
5
The roller presser 1 should be adjusted slightly towards the operator when
sewing very tight curves.
3
Adjustment
2
25