Table of Contents
Advertisement
Setup and connection
Location tips
• Select a stable, level base.
• Make sure that the environment is clean and free
from dust.
• Select a location away from heat sources and direct
sunlight.
• Do not place any heavy objects on the DecoderSta-
tion 6 or on the cables.
The receiver for the remote control signals is located
at the front of the device. You should therefore set
up the device so that you can see it from your sitting
position.
WARNING
Risk of injury/damage!
Lay the cables so that they do not pose a tripping
hazard.
FM antenna
WARNING
Risk associated with lightning strike!
If you are using outdoor or roof antennas, be abso-
lutely sure that the antenna has lightning protection.
To receive FM stations, connect the antenna to the
FM jack (6). This may be a roof/outside antenna, but
also a cable television connection. You will need a
coaxial connector cable for this.
If no antenna connection is available at the set-up lo-
cation, you can use the enclosed throw-out aerial
Push the antenna plug into the FM jack (6) and adjust
the position of the throw-out aerial for best reception.
Then fix the antenna in place.
10
• DecoderStation 6
.
6
Advertisement
Table of Contents
