Table of Contents
Advertisement
Setup / Connection
Setup location
NOTICE
If the device is subjected to
warm temperatures after being
cold (e.g. after transport), con-
densation may occur inside of
it.
– In this case, wait at least 2
hours before you connect and
activate it.
Location tips
Our website contains comprehen-
sive notes for correct setup.
• Select a stable, level base.
• Make sure that the environment is
clean and free from dust.
• Select a location away from heat
sources and direct sunlight.
• Lay the connector cables so that
they do not pose a tripping hazard.
• Do not place any heavy objects on
the cables or the AmpStation.
Connecting the speakers
Only connect speakers with an im-
pedance of 4 – 16 ohm. If possible,
use high-quality speaker cables with
a diameter of at least 1.5 mm
connection. You can order this type of
cables in our webshop (www.teufelau-
dio.com) in the "Accessories" area.
The connector terminals SPEAK-
ER OUT (5) for the eight speakers
are located on the back side of the
AmpStation:
Speakers
Rear right
Rear left
Surround right
Surround left
Additional chan-
nel (subwoofer)
Front centre
Front right
Front left
The terminals are each marked red (+)
and black (-).
Here you can connect the speaker
cables directly or using optional pin
plugs. Only the direct connection is
described below.
2
for the
Label
REAR RIGHT
REAR LEFT
SURROUND RIGHT
SURROUND LEFT
AUX
CENTER
RIGHT
LEFT
• AmpStation
9
Advertisement
Table of Contents
