Remote Control - Teufel DecoderStation 6 Technical Description And Instruction Manual

Inserting/changing the battery
You should change the two batteries if the remote
control stops working properly or after 2 years at the
latest. Battery type: Micro or AAA with 1.5 volts.
1. Gently depress the arrow on the battery compart-
ment cover on the back of the remote control. Push
the cover down and out.
2. If applicable, remove any old batteries (please ob-
serve the disposal notes on page 6).
3. Insert the batteries in the battery compartment as
shown in the figure.
4. Place the cover back on the compartment and push
it closed.
Functionality
The remote control relays the control signals by
means of infrared light. For this, you will have to point
the remote control at the DecoderStation 6. The in-
frared receiver is located on the front side. Make sure
that the infrared light is not obstructed by objects.
WARNING
Swallowing the product battery may result in severe
internal injury or even death.
• Store both new and used batteries so that they
are not accessible to children.
• If it is no longer possible to safely close the
battery compartment, stop using the product and
store it so that it is not accessible for children.
• If you suspect that a battery has been swallowed
or otherwise incorporated, promptly consult a
physician.
Leaking battery acid may lead to chemical burns.
• Do not allow battery acid to come into contact
with skin, eyes or mucus membranes. In the
event of contact with acid, immediately flush the
applicable areas with plenty of clean water and
consult a physician if necessary.
WARNING
Batteries (particularly lithium batteries) can explode
if used improperly.
• Never attempt to charge the battery.
• Only insert a battery of the same or equivalent
type (Micro or AAA with 1.5 volt).
• You may not heat or short circuit batteries and
rechargeable batteries or dispose of them in fire.
• Do not expose batteries and rechargeable batter-
ies to direct sunlight.

Remote control

• DecoderStation 6 13