Table of Contents
Advertisement
About reflection of light from outside or
IR light
Depending on the incident angle of high inten-
sity light source such as sunlight or lighting,
images of non-existing objects (reflected light)
or reflections of surroundings on the camera
lens (ghost) may sometimes appear on the
screen. Especially in the case of LED light,
these phenomena may be seen remarkably.
In the case of using the IR light, installation of
a camera near a wall may cause reflection of
infrared rays resulting in a part of the screen
or the entire screen turning whitish. Therefore,
consider the installation place carefully.
• Refer to our website (https://security.
panasonic.com/support/info/ <Control
No.: C0109>) for image examples and
measures to take.
Protection from lightning
When cables are used outdoors, there is a
chance that they may be affected by lightning.
In such a case, install a lightning arrestor close
to the camera, and make the length of the net-
work cable between the camera and lightning
arrestor as short as possible to prevent the
camera from being damaged by lightning.
Grounding connection of the lightning
arrestor
With the camera mount bracket connected to
the earth ground, connect the ground of the
lightning arrestor (locally procured) to the fol-
lowing location of this unit. Procure locally all
the screws used for connecting.
Recommended fixing screws: M3×8 mm with
spring washer
Take notice of humidity
Install this product when the humidity is low. If
installation is performed when it is raining or in
very humid conditions, the inside may be
affected by humidity, causing mist-over inside
the front panel.
When noise disturbance may happen
Conduct the power distribution work to keep a
distance of 1 m {3.28 feet} or more from the
120 V (for U.S. and Canada) or 220 V – 240 V (for
Europe and other countries) power line. Or con-
duct the electric conduit work separately (Always
connect the metal pipe with grounding).
Radio disturbance
Noise may appear in video or audio near a
strong electric field from a TV or radio antenna,
motors and transformers, or a strong electric
field/magnetic field from a power line (lamp line)
of AC100 V or more.
PoE+ (Power over Ethernet Plus)
Use a PoE+ hub / device that is compliant with
IEEE802.3at standard.
It is impossible to supply the power to this
product from a PoE hub that is compliant with
IEEE802.3af standard.
Router
When connecting this product to the Internet,
use a broadband router with the port forward-
ing function (NAT, IP masquerade).
Refer to the Operating Instructions on the
Panasonic support website for further informa-
tion about the port forwarding function.
Time & date setting
It is necessary to set the time & date before
Connection
putting this product into operation. Refer to the
position
Operating Instructions on the Panasonic sup-
port website for descriptions of how to perform
the settings.
Make sure to remove this product if it will
no longer be used.
16
Hide quick links:
Advertisement
Table of Contents
