Panasonic WV-X6533LN Important Information Manual page 11

[Precautions for use]
When the product is accessible from the
Internet
To prevent unauthorized access, note the fol-
lowing.
• Leave user authentication turned on.
• Periodically change passwords that are
used to access the product.
Refer to the Operating Instructions on the
Panasonic support website for information
about how to change passwords.
To keep on using with stable performance
Do not use this product in hot and humid con-
ditions for a long time. Failure to observe this
causes component degradation resulting in life
shortening of this product. Do not expose this
product to direct heat sources such as a heater.
This product has no power switch.
When turning off the power, disconnect the
power supply from the 24 V AC power supply,
the tested PoE injector or the PoE+ device.
Turning the power supply ON and OFF
frequently can lead to malfunctions.
Handle this product with care.
Do not drop this product, nor apply shock or
vibration to the product. Failure to observe this
may cause trouble.
About the battery
A battery is installed inside the camera. Do not
leave the battery exposed in environments of
excessive heat as a result of sunlight or fire.
Do not subject the front panel to strong
impact.
Doing so may cause damage or immersion.
Do not touch the front panel directly with
your bare hands.
A dirty front panel causes deterioration of pic-
ture quality.
When an error is detected, this product
will restart automatically.
This product will be inoperable for around 2
minutes after the restart just as when the
power is turned on.
About the automatic status detection
function
When this product malfunctions due to exoge-
nous noise, etc. for 30 seconds or more, the
product will automatically reset and will return to
normal state. When the product is reset, initializa-
tion will be carried out as when the power of the
product is turned on. When the product repeat-
edly resets, exogenous noise level around the
product may be high and that may cause mal-
function. Contact your dealer for instructions.
Periodically images on the screen appear
to be distorted
When the camera is installed in a location where
it is subject to small vibrations (for example,
when it is installed near devices that vibrate),
images may appear distorted and stretched
lengthways. This phenomenon is a characteris-
tic of image pickup devices that use CMOS sen-
sors and is caused by the relationship between
the periodic movements of the camera and the
timing that the image sensor reads images. This
is not a problem with the camera. To reduce the
possibility of this phenomenon occurring, install
the camera in a secure location.
What to do if "WARMING UP-PLEASE
WAIT" appears on the display.
This message indicates that the temperature
inside the camera has become extremely low.
The camera will be automatically restarted
when the inside the camera is warmed up by
the built-in heater. Please wait for a while.
We shall not be liable for content
compensation, losses of recorded or
edited content and any direct or indirect
consequent damages caused by failure to
record or edit due to faults with this unit or
the SD memory card. In addition, the same
provisions apply after unit is reparied.
11