Introduction; Installation - Optical Systems Design OSD2512 Quick Start Manual

1 INTRODUCTION

Thank you for choosing the OSD2512 14-Port Gigabit Managed Ethernet Switch. This Quick Start
Guide is designed to guide you through the installation and basic software function.

2 INSTALLATION

ELECTROMAGNETIC COMPATIBILITY
WARNING: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
OPTICAL OUTPUT OPERATION
WARNING: Laser Safety: Class 1 Laser Product (SFP) per IEC 60825-1:2014 standard.
PRECAUTIONS
▲ All service personnel should be provided training as to the hazards of direct viewing of laser
radiation and of the precautionary measures during servicing of equipment
▲ Areas where laser products are installed should be restricted in access to trained service
personnel only and appropriate warning signs posted in the work area.
▲
All laser apertures should be covered by protective covers when not connected to optical
fibers. Never leave outputs uncovered.
▲
Laser equipment should be positioned above or below eye level where possible. Apertures
should be positioned away from personnel.
▲ Protective eyewear should be worn in the vicinity of laser equipment.
PAGE 4
OPTICAL SYSTEMS DESIGN
The OSD2512 is a Class 1 laser product.
OSD2512 QUICK START GUIDE
Class 1
DOC ID: 10116701