Lincoln Electric Wire Feed Module 12207 Operator's Manual page 11

WIRE FEED MODULE™
ASSEMBLE WFM INTO THE CLASSIC
300 ® HE WELDERS:
INSTALLATION SEQUENCE:
CLASSIC ® 300HE (See Exploded View the following Page)
1. Remove the bottom 5 fastener buttons from the upper control
nameplate. Keep the fastener buttons for later use to fasten the
WFM nameplate. Once, the fastener buttons have been
removed snap / break off the lower section of the nameplate
(the section with the welder name on it).
1. REMOVE 5 FASTENER BUTTONS
2. Attach the WFM nameplate to the upper control panel on the
welder below the original nameplate with 5 fastener buttons.
REPLACE 5 FASTENER BUTTONS
3. Install the following Items into the welder control panel:
• Item 1 Amphenol receptacle and cap.
• Item 2 Potentiometer, Seal, Spacer and secure the knob.
• Item 3 Local/remote toggle switch (keep all wires connect-
ed to it mounting tab down).
• Item 4 CV/CC toggle switch (keep all wires connected to it
mounting tab down).
300HE AND SAE-
®
2. SNAP / BREAK OFF
IN THIS AREA
Item 1
Item 2
Item 3
Item 4
INSTALLATION SEQUENCE:
SAE-300 HE (See Exploded View the following Page)
®
1. Remove the bottom 3 mounting screws from the upper control
nameplate. Keep the screws for later use to fasten the WFM
nameplate. Once, the screws have been removed snap / break
off the lower section of the nameplate (the section with the
welder name on it).
2. Attach the WFM nameplate to the upper control panel on the
welder below the original nameplate with 5 mounting screws.
3. Install the following Items into the welder control panel:
• Item 1 Amphenol receptacle and cap.
• Item 2 Potentiometer, Seal, Spacer and secure the knob.
• Item 3 Local/remote toggle switch (keep all wires connect-
ed to it mounting tab down).
• Item 4 CV/CC toggle switch (keep all wires connected to it
mounting tab down).
A-3
INSTALLATION
2. SNAP / BREAK OFF
IN THIS AREA
1. REMOVE 3 MOUNTING SCREWS
REPLACE WITH 5 MOUNTING SCREWS
Item 1
Item 2
Item 3
Item 4