Table of Contents
Advertisement
2-1-3 Switch Panel
To access the switch panel, open the lower control
panel.
On how to open the lower control panel, see the figure on
page 2-2.
1 Memory stick slot
Use this to update the firmware. You can also save or
load setup menu settings onto the memory stick.
Note
After inserting a memory stick, allow at least five
seconds to elapse before removing it.
For details on firmware update and save or load setup menu
settings, refer to the Maintenance Manual Volume 1.
2 KEY INHI switch
Moving this switch to the ON position disables the
controls on the upper and lower control panels.
You can specify which buttons and knobs are disabled
in setup menu item 118.
KEY INHI
PANEL SEL
ON
OFF
REAR
FRONT
3 PANEL SELECT switch
2 KEY INHI switch
1 Memory stick slot
3 PANEL SELECT switch
In addition to the lower control panel, you can connect
a similar control panel to this unit. When two control
panels are connected to the unit, the PANEL SELECT
switch is used to specify which panel be enabled to
control the unit.
FRONT: Enables the control panel connected to the
REAR: Enables the control panel connected to the
4 CONTROL PANEL connector (10-pin, round
type)
Plug in the lower control panel connection cable.
CONTROL PANEL
4 CONTROL PANEL connector
CONTROL PANEL connector 4 on the switch
panel.
CONTROL PANEL connector on the connector
panel. When setup menu item 117 is set to PARA,
this switch position also enables the control panel
connected to the CONTROL PANEL connector
on the switch panel.
Chapter 2 Location and Function of Parts
2-15
Advertisement
Table of Contents
