Switch Panel - Sony HDW-M2100 Operation Manual

7 LEARN button
After setting a speed variation start point (STUNT IN
point) and a speed variation end point (STUNT OUT
point), pressing this button makes the tape start
running. You can then use the search dial to vary the
tape speed, which is automatically stored in memory.
After thus storing the tape speed variation in memory,
pressing this button starts an automatic playback
between the speed variation start and end points at the
stored speed.
qa Shot mark section
1 LIST button
2 REC/ERASE indicator
LIST GOOD SHOT MARK
REC/
3 MARK button
ERASE

2-1-3 Switch Panel

To access the switch panel, open the lower control
panel.
On how to open the lower control panel, see the figure on
page 2-1.
1 LIST button
Use this button to read in and list shot marks.
2 REC/ERASE indicator
This lights in the state in which writing, amending, and
deleting of shot marks is enabled and flashes while a
shot mark is actually being written, amended or
deleted.
3 MARK button
Hold this button down for 2 seconds or more, to enable
writing, amending, and deleting of shot marks.
1 Memory card slot
KEY INHI PANEL SEL
OFF REAR FRONT
ON
4 PANEL SELECT switch
5 KEY INHI switch
6 Memory stick slot
2 Memory card ejection button
3 CONTROL PANEL connector
CONTROL PANEL
Chapter 2 Location and Function of Parts
2-11