Table of Contents
Advertisement
Menu items in the range 300 to 399, relating to editing operations (Continued)
Item number Item name
334
EE REFERENCE
CONTROL
EDIT PRESET INHIBIT IN
336
KEY PANEL CONTROL
337
EXTERNAL REFERENCE
SELECT
338
OUTPUT AUDIO/TC
PHASE
Item number Item name
401
FUNCTION MODE
AFTER CUEUP
402
TIME REFERENCE FOR
PREROLL
403
AUTOMATIC PREROLL
REFERENCE ENTRY
405
CUEUP BY CTL
a) When controlled from an editor (BVE-2000/9100 etc.),
selecting "REEL" allows high-speed cuing up.
Settings
Specify how to select the reference video signal in E-E mode.
[NORMAL]: Select according to the table in Section 3-2-1 "Selecting Reference
Signal Depending on Operational Status" (page 3-3) .
INPUT: In E-E mode select the input video signal. When not in E-E mode, select
according to the table in Section 3-2-1 "Selecting Reference Signal Depending
on Operational Status" (page 3-3) .
Specify which buttons are disabled in the editing mode setting section on the
lower control panel.
[OFF]: Disable no buttons.
TC: Disable the TC button.
Select the signal used when this unit is set up by setup menu item 309 and
F2(OUTREF) in function menu page 4 to use an external reference video signal.
[HD]: Use a high definition reference video signal. Input a three-valued (positive
and negative) sync signal to the REF.VIDEO INPUT connector.
SD: Use a reference video signal. Input a video signal with chroma burst (VBS) or
a monochrome video signal (VS) to the REF.VIDEO INPUT connector.
Note
When operating in 24PsF or 23.98PsF mode, the setting is HD and this item is not
displayed.
Set the audio (AES/EBU and analog) and time code output phase.
[HD]: Sync with HDSDI output phase.
SD: Sync with SD output phase.
Note
When operating in 24PsF or 23.98PsF mode, the setting is HD and this item is not
displayed.
Menu items in the range 400 to 499, relating to preroll
Settings
Select the state that the unit goes into after a cuing-up operation.
[STOP]: Stop (the "stop mode")
STILL: Still playback (in search mode)
Note
When controlling this unit from an editor with the standard constants set, select
"STOP".
When prerolling a tape with time code discontinuities, select whether or not to use
CTL pulses to count time code from before a discontinuity.
[CTL]: Use CTL pulses to count time code.
TC: Do not use CTL pulses to count time code.
Select whether or not the edit IN point is automatically set by pressing the
PREROLL button, when the IN point is not set before starting preroll.
[DIS]: IN point is not set automatically.
ENA: IN point is set automatically.
Select the tape transport mode when cuing. This setting is valid only when the
function menu item CTL/TC is set to CTL.
[CAP.]: During cuing up, the tape transport is in the "pinch ON" state (maximum
tape speed 10 times normal).
REEL : During cuing up, the tape transport is in the "pinch OFF" state. As the
tape approaches the cue up point and the tape speed drops, the tape transport
switches to the "pinch ON" state.
To give priority to editing accuracy, select "CAP".
a)
Chapter 10 Setup Menus
10-17
Advertisement
Table of Contents
