User Guide - infaco A3M V2.0 Instructions For Using Manual

MAKING A TIE (the machine should be switched on).
Hold the end of the branch and the
trellising wire firmly in your free hand and
bring the A3M V2 closer.
Position the tying head just before the
last node on the branch.
Move the machine back firmly to release
the tying head: the wire then wraps round
the branch. Press control switch 01 to
complete the tie.
01
The knot is made more or less tight
depending on how far you pull back
the machine: See next chapter.
Version 3

USER GUIDE

GENERAL POINTS ON TYING METHODS.
See attached sheet:
"APPROPRIATE TYING METHODS P18"
Firmly place the branch + the trellising
wire inside the tying head.
01
Go right up to the abutment to ensure
that the arm closes fully and attaches
the wire correctly.
The tie holds the branch on the trellising
wire.
-7-