Operating Problems - infaco A3M V2.0 Instructions For Using Manual

Unless stated to the contrary, these tasks should be carried out with the
machine disconnected.
THE LOOP NO LONGER FORMS AROUND THE BRANCH DURING THE TYING
A piece of wire may be stuck in the
wire pincher 01.
01
The wire may be bent at exit 01: (no need to disconnect the machine) simply go
through the cycle empty or run the knife only and resume the tying action.
Version 3

OPERATING PROBLEMS

OPERATION
To release it, press pin 02 in the circular
orifice with your fingernail or using the
supplied pliers.
02
01
-13-