infaco A3M V2.0 Instructions For Using Manual page 17

THE TYING HEAD IS STUCK, THE MACHINE NO LONGER OPERATES
Push rod 01, which hits against ring 02
when the wire is cut, sometimes goes out
of its trajectory and become stuck on the
outer edge of ring 02. The arm 03 often
remains locked and can't open completely
Do not try to force arm 03 open as you
may damage the mechanism.
01
03
Ring 02 is released when the push rod has returned to its initial position. The arm 03
must be fully open. Check that the tying head can turn freely again. You can then
switch the machine back on and resume tying operations.
Version 3
02
01
03
Bring tying head 01 in to a central
working position, following the arrow
below. Then take hold of ring 02 and
move it forwards and backwards until the
push rod returns to its position beneath
ring 02.
It is normal for the tying head 01 to resist
and make you force it to bring it back into
its operating position.
02
01
02
-15-