Rear Panel - Sony 85P Operating Instructions Manual

Location and Function of Parts
8 MONITOR SELECT switches
Use these switches to select the channels for audio
output via the MONITOR AUDIO connector on the
rear panel and the HEADPHONES connector on the
front panel.
Use the left switch to select the basic channel setting,
then use the right switch to select the output format
(monaural, stereo, or mix).
The table at right lists the correspondence of left/right
switch settings and channel/output format selections.

Rear Panel

REF.VIDEO
AC IN
1 AC IN connector
Connect to an AC power outlet using the supplied
power cord.
2 TBC (time base corrector) REMOTE connector
(15-pin)
To remote-control the built-in time base corrector,
connect an optional TBC remote controller such as the
UVR-60/60P, BK-2006/2007 or BVR-50/50P.
14
Chapter 1 Overview
ANALOG I/O
QSDI
VIDEO IN VIDEO OUT
DIGITAL AUDIO
COMPONENT VIDEO
TIME CODE
S VIDEO
MONITOR
AUDIO
1 AC IN connector
2 TBC REMOTE connector
3 REMOTE connector
Switch setting
Left Right
switch switch
CH- CH-
1/3 2/4
MIX
CH- CH-
CH- CH-
1/3 2/4
1/2 3/4
MIX
CH- CH-
1/3 2/4
MIX
CH- CH-
1/3 2/4
MIX
CH- CH-
CH- CH-
1/3 2/4
1/2 3/4
MIX
CH- CH-
1/3 2/4
MIX
SDI INPUT SDI OUTPUT
(AES/EBU)
TBC REMOTE REMOTE
Notes
• Be sure to power off this unit before connecting the
TBC remote controller to the TBC REMOTE
connector.
• Only analog outputs (outputs of the connector 6, 8
and 0 in 1 analog video signal input/output
section) can be controlled remotely.
3 REMOTE connector (9-pin)
When controlling this unit from an editing controller
such as the ES-7, PVE-500, BVE-600/800/910, or
RM-450/450CE, connect the unit to the editing
controller via this connector using the supplied 9-pin
remote control cable.
Selected channel and output format
HEADPHONES MONITOR AUDIO
connector connector
Channel 1 only Channel 1 only
(monaural) (monaural)
Channels 1 and 2 Channels 1 and 2
(stereo) (mix)
Channel 2 only Channel 2 only
(monaural) (monaural)
Channel 3 only Channel 3 only
(monaural) (monaural)
Channels 3 and 4 Channels 3 and 4
(stereo) (mix)
Channel 4 only Channel 4 only
(monaural) (monaural)
1 Analog video signal input/
output section (see page 15)
2 Digital signal input/output
section (see page 16)
3 SDI signal input/output
section (with the optional
DSBK-120/120P installed)
(see page 17)
4 Analog audio signal input/
output section (see page 18)