Schematics - Mcube MC3635 Quick Start Manual And Demo

MC3635 3-Axis Accelerometer

6 SCHEMATICS

Above is a diagram showing setup for SPI protocol. This is the factory preset when receiving
the part.
For other options, please refer to the following table:
Interface
SPI @ 1MHz (Factory default)
SPI @ 2MHz or I2C 0x6C
I2C 0x4C (0x98)
I2C 0x6C (0xD8)
DNI = Do not install
R4, R5: Install ~4.7KΩ as the I2C pull-ups if using I2C mode and there is no I2C pull-ups
installed. (DNI by default)
Note: It is recommended not to install more than one pull-ups per I2C bus.
R6: Install ~4.7KΩ
pull-up resistor if setting the sensor interrupt pin to open-drain. (DNI by default)
R7: Sensor's driving current can be measured by putting an ammeter in place of R7.
mCube Proprietary.
© 2018 mCube Inc. All rights reserved.
EV3635A Quick Start Guide and Demo
R1
4.7KΩ to 100KΩ
4.7KΩ
4.7KΩ
4.7KΩ
APS-045-0017v1.1
R2 R3
4.7KΩ DNI
1KΩ DNI
DNI 4.7KΩ
4.7KΩ
DNI
12 / 17