Sony RM-VL600T Operating Instructions Manual page 28

Adding an Extra Function to the
Component Select Buttons
(continued)
To cancel the setting, press SET.
To programme the Power-On
command
Repeat the same procedure,
pressing the desired Component
Select button.
Notes
• If the component code of a non-Sony
brand has been set on a Component
Select button, you cannot programme
the Power-On function on it. If you
change the component code (page 10)
after setting the Power-On function,
the Power-On function is cleared.
(The Component Select button flashes
twice to indicate that you cannot set
this function.)
• Even if you used the Learning
function (page 16) to programme a
signal on a Component Select button,
you can programme the Power-On
function on that button but it cannot
be used. If you clear the "learned"
function on that button, you can use
the Power-On function.
GB
28