Module
2.5 Configuring
2.5.4.2
Digital outputs
Configuration
The GSM alarm module has four outputs with changeover contact. The following objects can
be configured/activated on the associated tabs:
● Name (this name must be unique and cannot be used with any other input or output. The
defaults are DO1 to DO4.)
● After a digital output has been switched, the module sends a confirmation message
followed by the new status of the output ("auto message"). This message is sent only to
the sender of the settings.
● If you activate "Send only user defined text", the module only sends the text defined in the
message box (no module name, IO name or timestamp).
● Defining your own commands for controlling the outputs (On instruction, Off instruction,
one-shot instruction).
● Activating switching (changeover) of the output (response to RING) when the module is
addressed by a telephone call.
● Linking DO with DI
● Switching on when there is no connection to the GSM network
● Retaining the status on restart
28
GSM alarm module
System Manual, 06/2014, 2541304131-01