Download Print this page
Walrus TQ Series Instruction Manual

Walrus TQ Series Instruction Manual

Electronic control pump

Advertisement

Quick Links

Limited Warranty
Products manufactured by Walrus Pumps Co (Walrus) are warranted to the first user only
to be free of defects in material and workmanship for a period of 12 months from date of
installation, but no more than 24 months from date of shipment. Walrus' liability under this
warranty shall be limited to repairing or replacing at our election, without charge, FOB
Walrus' distribution center or authorized service agent. Walrus will not be liable for any
cost of removal, installation, transportation or any other charges that may arise in
connection with warranty claim.
The warranty period commences on the date of original purchase of the equipment. Proof
of purchase and installation date, failure date, and supporting installation data must be
provided when claiming repairs under warranty.
This warranty is subject to due compliance by the original purchaser with all directions and
conditions set out in the installation and operating instructions. Failure to comply with
these instructions, damage or breakdown caused by fair wear and tear, negligence, misuse,
incorrect installation, inappropriate chemicals or additives in the water, inadequate
protection against freezing, rain or other adverse weather conditions, corrosive or abrasive
water, lightning or high voltage spikes or through unauthorized persons attempting repairs
are not covered under warranty.
Walrus will not be liable for any incidental or consequential damages, losses, or expenses,
arising from installation, use, or any other causes. There are no express or implied
warranties, including merchantability or fitness for a particular purpose, which extend
beyond those warranties described or referred to above.
Certain states do not permit the exclusion or limitation of incidental or consequential
damages or the placing of limitations on the duration of an implied warranty, therefore, the
limitations or exclusions herein may not apply. This warranty sets forth specific legal rights
and obligations, however, additional rights may exist, which may vary from state to state.
Supersedes all previous publications
Web: www.walruspump.com
E-mail: walrus.pump@msa.hinet.net
Walrus Pump Co., Ltd.
®
TQ Series
TQ Series
T T Q Series
Q Series
Electronic Control Pump
Instruction Manual
ISO 9001 Certified
Walrus Pump Co., Ltd.
®
50Hz

Advertisement

loading

Summary of Contents for Walrus TQ Series

  • Page 1 12 months from date of ® installation, but no more than 24 months from date of shipment. Walrus' liability under this warranty shall be limited to repairing or replacing at our election, without charge, FOB Walrus' distribution center or authorized service agent.
  • Page 2: Ec Declaration Of Conformity

    Manufacturer: I. Product must be positioned so it has an upward The TQ series are designed for the pumping of slope to the pump (thus avoiding the Walrus Pump Co., Ltd. non-aggressive water, or water not containing formation of air pockets).
  • Page 3: Operation And Maintenance

    IX. Operation and maintenance c. Replace the filling plug Single-phase power supply Under normal operating conditions, the pump does not require any maintenance as long as the following points are observed: 1. Periodically check the condition of the check Input power Grounding value and strainer (if used).
  • Page 4 Instructions for pressure adjustment (Fig. 5): XII. Adjust flow switch 1. If pump does not start when tap is on, adjust Following the adjustment of the pressure clockwise ("+") till it starts. switch, and with the unit running, close all 2.
  • Page 5: Frequently Asked Questions

    XIII. Frequently asked questions: XIV. Dimensions: (mm) 4. What is the purpose of the built-in 1. What causes the TQ to start? pressure tank? The TQ has the built-in pressure switch and TQ200/400/800 The pressure tank comes from the factory internal flow switch.
  • Page 6: Troubleshooting

    XV. Troubleshooting Before starting work on the pump, make sure that the electricity supply has been switched off and that it cannot be accidentally switched on. Problem Cause Remedy 1. pump does not a. No power supply Connect the electricity supply b.

This manual is also suitable for:

Tq200Tq400Tq800Tq1500Tq2200Tq3700