Skier's Choice Moomba Series 2019 Owner's Manual page 93

C T
ONNECTING THE RAILER
NOTE: If your hitch ball has an excessive at spot on
top, the latch may not engage properly. If the latch
does not catch, check with your dealer or hitch installer
before trailering.
92
When connecting the trailer to your tow vehicle, use the
following procedure:
1. Raise the tongue with the trailer jack, position the trailer tongue
directly over the 2" ball, and lower the jack until the tongue goes
all the way down over the ball.
2. Press down on the latch until it locks on the ball with a "click. "
3. Insert the locking pin into the tongue. Lock pin hole is on the side
of the tongue.
4. When all weight is o the trailer jack, pull the jack lock pin and rotate
the jack to the horizontal position and re-lock the pin.
5. Attach the safety cables to the tow vehicle hitch. Cross the cables
and wrap them around each other once or possibly twice allowing
just enough slack to permit tight turns of the vehicle and trailer.
6. Plug the trailer lights connector to the vehicle harness.
7. Clip the brake lockout cable to the vehicle hitch.
© 2018 Skier's Choice, Inc.