Troubleshooting - Verilux ClearWave CW01 Manual

Please refer to page 20 for troubleshooting the installation of the Treatment Head.
The Issue
The Treatment Head Indicator Light displays:
The treatment
cycle will not start
The Treatment Head Indicator Light displays:
The Treatment Head Indicator Light displays:
Battery will not hold a charge
Device will not turn on
Device shuts off
in cycle
CW01_MAN_Rev52.indd 24
CARE & CLEANING

Troubleshooting

The audio signals: 5 beeps
The Information Display signals:
The audio signals: 3 beeps
The Information Display signals:
The audio signals: 3 beeps
The Information Display signals:
The audio signals: 5 fast beeps
The audio signals: 10 beeps
The Information Display signals:
The audio signals: 10 beeps
The Information Display signals:
The Problem
Treatment head may not be
attached, or the Treatment
head is defective
The treatment head
has no remaining
treatment cycles
The battery is low
The device is too
cold to operate
The device is too
hot to operate
The battery needs to
be replaced
The battery is dead
The device needs
to cool down
24
The Solution
Properly and fully attach
treatment head.
Replace the treatment head.
Recharge the battery.
Set the device aside until it
reaches room temperature.
Set the device aside until it
reaches room temperature.
Order a replacement battery.
Charge battery
Set the device aside
and let it cool down.
8/2/11 12:38 PM