Verilux ClearWave CW01 Manual page 22

Instructions, Operation and Directions for Use — continued
When the "Information Display" is displaying "CP", the device has
been exposed to temperatures below -15° Celsius (5°F) and will
not operate properly. Set the device aside and allow it to reach
room temperature before using.
Note: Consecutive uses and high ambient temperatures can cause the Treatment Head
surface to become hot. The device monitors the Treatment Head surface temperature
during each treatment cycle to ensure that the Treatment Head maintains an optimum
temperature. If the device exceeds the optimum temperature limit, it will enter Heat
Protection Mode and device will limit operation until sufficient surface cooling has been
achieved.
When the "Information Display" is displaying "HP" the
device has reached or exceeded its optimum temperature
limit and will not continue to operate until a cool down
period has been completed.
If your device enters Heat Protection Mode:
The "Information Display" will display "HP" and the device will beep 10 times and
immediately terminate the treatment cycle.
Step 1: Set the device back on the Charging Stand and allow cooling.
Step 2: Once "HP" is no longer visible in the Information Display, the device is ready
for use.
Step 3: Resume normal operation as outlined on page 18 of this manual.
Note: Heat protection mode can be avoided by allowing the unit a short cool down
period between treatment cycles.
An additional head may be purchased and interchanged if many consecutive treatments
are required on a regular basis.
CW01_MAN_Rev52.indd 22
Cold Protection Mode
Heat Protection Mode
22
8/2/11 12:38 PM