Verilux ClearWave CW01 Manual page 19

Instructions, Operation and Directions for Use — continued
Checking the Status of the Clearwave
Step 1 Be sure the device is turned off. To place the device into status mode, press
and quickly release the power button. The device will remain in status mode
for approximately 30 seconds.
Step 2 The battery life indicator displays the respective status of battery charge levels.
The display will show the number of cycles remaining on the Treatment Head.
Step 3 When 30 seconds have elapsed, the device will shut off.
Information Display Indicators
Display Mode
Number Operating
Number Idle
0 Idle
- - -
LO
HP
CP
Treatment Head Life Indicator and Battery Life Indicator
3 lights
2 lights
1 light
Flashing light
CW01_MAN_Rev52.indd 19
f.
b.
a.
c.
d.
e.
Time remaining on current treatment cycle
Number of treatment cycles remaining on head
Treatment Head is exhausted
Treatment Head is not correctly attached
Device requires cooling
Device is too cold to operate
Treatment Head Life Indicator Light
More than 75 treatments remaining
Between 75 and 25 treatments remaining
Fewer than 25 treatments
Head needs to be replaced
Device
®
Controls
a. Power Button
b. Head Latch Buttons
Status Indicators
c. Information Display
d. Battery Life Indicator Lights
e. Treatment Head Life Indicator Lights
f. 32 LED Lamps
Explanation
Battery is low
Battery Life Indicator Light
More than 75% of the battery is charged
25% to 75% of the battery is charged
Less than 25% of the battery is charged
Battery needs to be charged
19
Reference
See Page 18
See Page 19 or 20
See Page 20
See Page 20
See Page 21
See Page 22
See Page 22
8/2/11 12:38 PM