Verilux ClearWave CW01 Manual page 20

Instructions, Operation and Directions for Use — continued
Note: The device monitors each treatment cycle to ensure that the Treatment Head is
delivering a complete and effective dose. Once the LEDs have passed their guaranteed
100% output life where a complete treatment dose cannot be assured, the Treatment Head
will expire and the device will cease to function until the Treatment Head is replaced. To
purchase new Treatment Heads, contact Verilux Customer Service at 1-800-786-6850 or
visit www.verilux.com. Dispose of used Treatment Heads per local regulations for electronic
waste.
The number of treatment cycles remaining on a Treatment Head
is displayed by both the device's Information Display and on the
Treatment Head Life Indicator (See page 19 for additional information.)
Push and release
latch buttons
New Treatment Heads may be
purchased at www.verilux.com
or by calling Customer Service
at 1-800-786-6850
CW01_MAN_Rev52.indd 20
CARE & CLEANING
Replacing the Treatment Head
When the bottom "Treatment Head Life Indicator
Light" is flashing and the "Information Display" is
displaying "0" the Treatment Head needs to be
replaced.
To remove the expired Treatment Head:
Step 1: Press and hold both Head Latch Buttons
shown on each side of the Treatment Head.
Step 2: Separate the Treatment Head from the Device
Body.
To install a new Treatment Head:
Step 1: Align the three round plastic posts on the
back of the new Treatment Head with the
three post sockets on the Device Body. This
will also align the square latch holes on the
new Treatment Head with the Head Latch
buttons on the Device Body.
Step 2: Press and hold both Head Latch Buttons on
each side of the new Treatment Head.
Step 3: Press the new Treatment Head into place
against the Device Body and release the Head
Latch Buttons.
Step 4: Press Power Button for approximately 1
second to activate Status Mode (see page
19). The Information Display should now
display the amount of cycles remaining on the
new Treatment Head.
Step 5: Three dashed lines will appear if the new
Treatment Head is incorrectly installed.
Repeat the
installation process if 3
dashed lines appear.
20
removal and
8/2/11 12:38 PM