Table of Contents
Advertisement
Instructions, Operation and Directions for Use — continued
Step 3
Step 5
Step 6 Hold the device in place until the device beeps 2 times, indicating the
completion of a 3-minute treatment cycle.
Step 7 For each additional location to be treated, press the button until it beeps
once, place the device against the new area and the light will again illuminate
signifying the beginning of the next 3-minute treatment cycle.
Notes: • Treat only one area per treatment cycle.
Step 4
• Your daily treatment regime should not exceed three treatment cycles per
location.
• A second consecutive treatment to the same area may be performed.
• Waiting a short time between treatment cycles is suggested to prevent the
device from entering heat protection mode.
Interrupted Treatment
Note: You can continue treatment of the same area if you remove the device from your
skin prior to the completion of a 3 minute treatment cycle.
Step 1 If the device is removed from the skin during a treatment cycle and 3 minutes
have not elapsed, the device will beep for 30 seconds.
Step 2 If you wish to continue treating the same area you were treating and 30
seconds have not elapsed, reapply the device to your skin.
Step 3 The display on the device will show the remaining treatment time if you do
not reapply the device to your skin. The Treatment Head life indicator and the
battery indicator will display the status of the device. If you do not reapply
the device to skin in 30 seconds, the device will shut off.
CW01_MAN_Rev52.indd 18
Step 5 Place the device against the desired
treatment area of your skin. The treatment
lights will automatically turn on once in
contact with the skin. This indicates that the
treatment cycle is beginning.
f.
Controls
b.
a. Power Button
b. Head Latch Buttons
a.
Status Indicators
c. Information Display
c.
d. Battery Life Indicator Lights
d.
e. Treatment Head Life Indicator Lights
f. 32 LED Lamps
e.
18
8/2/11 12:38 PM
Advertisement
Table of Contents
