Connecting An Aerial And A Vcr; Switching On The Tv - Sony Trinitron KD-32DX40U Operating Instructions Manual

DX40 Pages 1-10.fm Page 5 Wednesday, August 22, 2001 12:06 PM

3. Connecting an aerial and a VCR

Connecting an aerial only
RF Loopthrough
cable (supplied)
Connecting an aerial and a VCR
Scart lead
(not supplied)
Rear of VCR

4. Switching on the TV

Existing aerial lead
Existing aerial lead
RF Loopthrough
cable (supplied)
RF Lead
(not supplied)
On/Off button
1 Connect your existing aerial lead to the upper socket
marked 1 on the rear of the TV as shown.
2 Connect the supplied RF loopthrough cable to the
sockets marked 2 and
1 Connect your existing aerial lead to the upper socket
marked 1 on the rear of the TV as shown.
2 Connect the supplied RF loopthrough cable from the
aerial socket marked on the TV to the RF input
socket of your VCR.
3 Connect an RF lead from the RF output of your VCR
to the TV socket marked 2.
4 Connect a scart lead from the scart socket marked
2/ on the rear of the TV to a scart socket on
s
your VCR (Refer to the VCR instructions).
5 Connect the VCR to the mains socket and switch on.
6 Insert a pre-recorded tape into the VCR and press
the 'PLAY' button. This enables the TV set to locate
and store the video channel during the 'Automatically
tuning the TV' procedure.
1 Connect the TV plug to your mains socket (220 -
240V AC, 50 Hz) and switch on.
2 Push in the On/Off button ( ) on the front of the TV.
If the red standby mode indicator on the front of the
/
TV is lit, press the TV
control to switch on the TV set. Please be patient as
the picture may take a few moments to appear on the
TV screen.
Getting Started
as shown.
button on the remote
5
Getting Started