Whirlpool GI1500XH Technical Manual page 18

Removing the Electronic Control Board
1. With the control box in the service position, disconnect the three (3) wiring harness plugs from
the connectors on the electronic control board. (Fig. 3-9)
2. Remove the two (2) Hex-head screws securing the electronic control board to the mounting
stubs in the control box. (Fig. 3-9)
Removing the Push Button Switch Assembly
The push button switch assembly can be removed with the control box remaining in the service posi-
tion.
1. Disconnect the wires from the switch assembly terminals.
2. Remove the decorative overlay from the front of the control box. (Fig. 3-10)
Decorative
Overlay
3. Press in on the four locking tabs at the back of the switch assembly and push the entire switch
assembly.
NOTE: If the push button switch assembly must be replaced, the service replacement
assembly must be ordered by using the specific model number of the ice maker. The
service replacement switch assembly comes with a new decorative overlay.
Wiring Harness
Plug
Wiring
Harness
Plug
Fig. 3-9
Fig. 3-10
12
Wiring Harness
Plug