Accessing Component In The Control Box - Whirlpool GI1500XH Technical Manual

ACCESSING THE COMPONENTS IN THE CONTROL BOX
(This procedure is the same for long and short door units.)
Removing the Control Box
1. Remove the three (3) Phillips-Head screws securing the cutter grid cover to the cutter grid.
(Fig. 3-2)
Three (3) Screws
Fig. 3-2
2. Disconnect the three wiring harness plugs from the connectors at the bottom of the control
box. (Fig. 3-3)
3. Remove the Hex-head screw securing the
cutter grid mounting bracket to the right
side of the cabinet liner. (Fig. 3-4)
4. Loosen, but do not remove the Hex-head
screws securing the cutter grid mounting
bracket to the left side of the cabinet liner.
(Fig. 3-4) Then, lift the front of the cutter
grid up to release the Hex-head screw
from the key slot in the left side mounting
bracket and pull the cutter grid from the
cabinet.
5. Remove the four (4) Hex-head screws
securing the control box to the top of the
ice maker cabinet. (Fig. 3-5)
NOTE: The screws at the front of the
control box are recessed.
6. The control box can now be lowered into
the service position.
Wiring Harness Plugs
Fig. 3-3
Fig. 3-4
Fig. 3-5
11
Remove
Loosen
This
This Screw
Screw