Cisco Aironet 1530 Series Hardware Installation Manual page 14

Chapter 2 Installing the Access Point
When using the streetlight power tap adapter (AIR-PWR-ST-LT-R3P=), ensure that the access point is
Step 3
mounted within 3 feet (1 m) of the outdoor light control.
Step 4 Ensure that a 6-AWG ground wire is attached to the access point (see
streetlight pole (for instructions see
Figure 2-33
1
Outdoor light control
2
AC/DC power adapter
Note
Ensure that the streetlight power tap adapter, which uses a 3-pronged LC-10 twist-lock adapter, is placed
Step 5
between the outdoor light control and its fixture (refer to
designed to be used with LC-10 listed outdoor light controls operating at 100 to 480 VAC, 50 to 60 Hz.
Disconnect the outdoor light control from its fixture.
Step 6
Verify that the voltage available at the fixture is between 100 and 480 VAC, 50 to 60 Hz.
Step 7
Turn off power to the fixture at the designated circuits.
Step 8
Caution When installing the streetlight power tap adapter to the access point AC power connector, always
connect the access point end of the cable FIRST. When removing the streetlight power tap adapter,
always disconnect the access point end of the cable LAST.
Note
Connect the streetlight power tap adapter to the access point AC/DC power adapter. Hand-tighten the
Step 9
connector.
OL-30864-01
Using the Streetlight Power Tap Adapter
2
1
AC/DC
Adapter
Deployment of the AP as shown in the streetlight deployment in
alternate AP mounting kit. See
Ensure that your antennas are connected to the access point before you apply power to the access
point.
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
Grounding the Access Point, page
3
3
6-AWG copper grounding wire
Mounting the Access Point
Figure
Powering the Access Point
Figure 2-33) and connected to the
2-40).
Figure 2-33 requires an
section for more information.
2-33). The LC-10 twist-lock adapter is
2-51