Lancia Ypsilon Owner's Handbook Manual page 88

"ENERGY SAVING" FUNCTION
(for versions/markets, where provided)
GETTING TO
KNOW YOUR CAR
If, following automatic engine restarting, the
driver does not carry out any action on the car for
over 3 minutes, the Start&Stop system stops the
engine once and for all, to prevent fuel
SAFETY
consumption. In these cases, the engine can be
restarted only using the ignition key.
Note In any case, it is possible to keep the engine
STARTING AND
running by deactivating the Start&Stop system.
DRIVING
IRREGULAR OPERATION
WARNING LIGHTS In the event of malfunction, the Start&Stop
AND MESSAGES system is deactivated. The driver is informed
about the fault through the flashing of the symbol
on the display (for some versions through the
display of a message). In this case, go to a Lancia
IN AN EMERGENCY
Dealership.
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
86
CAR INACTIVITY
In the event of car inactivity, special attention
must be paid due to the disconnection of the
battery power supply.
Proceed as follows: detach the connector A fig. 70
(by pressing button B) from sensor C for
monitoring the status of the battery installed on
the negative battery pole D. This sensor should
never be disconnected from the pole except if the
battery is replaced.
WARNING
When replacing the battery, always
contact a Lancia Dealership. Replace
the battery with one of the same type
(HEAVY DUTY) and with the same
specifications.
fig. 70
L0F0083