Kohler 8-32EOZD Service page 84

7. Apply antiseize compound to the keyed end of the
rotor shaft. Bring the rotor leads through the bores
in the armature while installing the armature on the
shaft. Check the keyway of the shaft and key of the
armature for damage.
retaining bolt and washer.
8. Use screws and lock washers to install the rotor
leads to the rectifier board at the positive (+) and
negative (--) terminals.
Note: Position the lock washers against the
rectifier board.
9. Install the three spacers and bolts to mount the
rectifier board to the armature.
10. Position the field leads at the top. Install the exciter
field using four bolts and washers.
Figure 9-15.
1
2
1. Exciter field bolts (4)
2. Exciter field
Figure 9-15 Installing Exciter Field
84 Section 9 Generator Disassembly/Reassembly
Install the armature
See
5588614
11. Install tie wraps to secure the wires as necessary.
12. Reconnect the leads to the circuit breaker and
neutral stud (LO) as marked during disassembly.
Note: Check the generator set nameplate to verify
the original voltage configuration.
13. Reconnect the P1, P15, and P16 connectors.
Connect the ground strap using bolt, washer, and
lock washer (install the lock washer against the
ground strap).
14. Reinstall the ADC 2100.
15. Reinstall the junction box louvered panel.
16. Reconnect all of the external connections—the
exhaust line to the mixing elbow, the fuel line to the
fuel pump filter inlet, the water line to the seawater
pump, the remote interface connector, the AC
output leads, and the battery cables to the battery
(negative (--) lead last).
17. Verify that the generator set master switch is in the
OFF position.
18. Reconnect the engine starting battery, negative (--)
lead last.
19. Reconnect power to the battery charger, if
equipped.
20. Replace the sound shield roof and door(s), if
equipped.
TP-6255 7/06