Additional Rtu Open Installation And Troubleshooting; Economizer Systems - Carrier 48GC04 Service And Maintenance Instructions

WARNING
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal inju-
ry, death and/or equipment damage.
Disconnect and lockout/tagout electrical power before wir-
ing the RTU Open controller.
Additional RTU Open Installation and Trouble-
shooting
Additional installation, wiring and troubleshooting information
for the RTU Open Controller can be found in the following
manual: "48/50FC, 48/50GC Single Package Rooftop Units
with RTU Open Controls, Start-up, Operation and Trouble-
shooting Instructions."

ECONOMIZER SYSTEMS

The unit may be equipped with a factory-installed or accessory
(field-installed) economizer system. Three types are available:
two with logic control systems (EconoMi$er
EconoMi$er IV) and one without a control system
(EconoMi$er2). See Fig. 61 - 63 for component locations on
each type.
NOTE: For GC rooftop units EconoMi$er IV is only available as
a field-installed accessory.
Economizers use direct-drive damper actuators.
IMPORTANT: Any economizer that meets the economizer
requirements as laid out in California's Title 24 mandatory
section 120.2 (fault detection and diagnostics) and/or pre-
scriptive section 140.4 (life-cycle tests, damper leakage, 5
year warranty, sensor accuracy, etc), will have a label on
the economizer. Any economizer without this label does
not meet California's Title 24. The five year limited parts
warranty referred to in section 140.4 only applies to factory
installed economizers. Please refer to your economizer on
your unit.
OUTSIDE AIR
TEMPERATURE SENSOR
Fig. 61 — EconoMi$er X Component Locations
OUTSIDE AIR
TEMPERATURE SENSOR
® X and
Fig. 62 — EconoMi$er IV Component Locations
OUTSIDE AIR
TEMPERATURE SENSOR
Fig. 63 — EconoMi$er2 Component Locations
38
ECONOMI$ER X
HARNESS
LOW AMBIENT
ECONOMI$ER IV
SENSOR
CONTROLLER (W7212)
ECONOMI$ER2 PLUG