Table of Contents
Advertisement
KBefore using for the first
time
B efore you can use your new appliance, you must
B e f o r e u s i n g f o r t h e f i r s t t i m e
make some settings. You must also clean the cooking
compartment and accessories.
Cleaning the cooking compartment and
accessories
Before using the appliance to prepare food for the first
time, you must clean the cooking compartment and
accessories.
Cleaning the cooking compartment
To eliminate the new-appliance smell, heat up the
cooking compartment when it is empty and with the
oven door closed.
Make sure that there is no leftover packaging, such as
polystyrene pellets, in the cooking compartment and
remove the adhesive tape that is in or on the appliance.
Before heating the appliance, wipe the smooth surfaces
in the cooking compartment with a soft, damp cloth.
Keep the kitchen ventilated while the appliance is
heating.
Apply the settings indicated below. You can find out
how to set the heating function and the temperature in
the next section. ~ "Operating the appliance"
on page 17
Settings
Heating function
3D Hotair
Temperature
maximum
Time
1 hour
Switch off the appliance after the time indicated.
Once the cooking compartment has cooled down,
clean the smooth surfaces with soapy water and a dish
cloth.
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
:
Before using for the first time
1Operating the appliance
T his chapter explains how to set a hotplate. The table
O p e r a t i n g t h e a p p l i a n c e
shows heat settings and cooking times for various
meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the
sounds. The indicator next to the main switch and the
hotplate indicators
light up. The hob is ready to use.
‹
To switch off: Touch the
goes out. All hotplates are switched off. The residual
heat indicator remains lit until the hotplates have cooled
down sufficiently.
Notes
The hob will automatically switch itself off if all
■
hotplates have been switched off for more than
20 seconds.
The settings are stored for 4 seconds after the hob
■
has been switched off. If you switch the hob back on
during this time, the hob will operate using the
stored settings.
The maximum output of the hob depends on the
■
type of mains connection used. In order not to
exceed the maximum output limit, the hob
automatically distributes the power available
between the hotplates that are switched on.
The output of a hotplate can be temporarily
decreased to below the setpoint while the Power
Management function is active.
Setting a hotplate
Use the
and
symbols to select the required heat
@
A
setting.
Heat setting
= lowest setting.
‚
Heat setting
= highest setting.
Š
Every heat setting has an intermediate setting. This is
marked with a dot.
Notes
To protect the fragile parts of your appliance from
■
overheating and electrical overloading, the hob may
temporarily reduce the power.
In order to prevent the appliance from producing
■
excess noise, the hob may temporarily reduce the
power.
symbol. An audible signal
#
symbol until the indicator
#
en
17
Advertisement
Table of Contents
