Video Component Hookups - Sony TA-E9000ES Operating Instructions (primary manual) Operating Instructions Manual

Video Component Hookups

Note on video component hookups
You can connect your TV's audio output jacks to the TV
(TV/DBS) AUDIO IN jacks on the control amplifier and
apply sound effects to the audio from the TV. In this case,
do not connect the TV's video output jack to the TV (TV/
DBS) VIDEO IN jack on the control amplifier. If you are
connecting a separate TV tuner, connect both the audio
and video output jacks to the control amplifier as shown
below.
z
To connect equipment that alters the video signal
Use the PROCESSOR jacks. You can connect a video titler or
processor (etc.). When you output the video signals input to this
unit through the PROCESSOR OUT jacks and input the altered
signal to the PROCESSOR IN jacks, that signal is output from the
MONITOR OUT and VIDEO REC OUT jacks (see the "Video
Signal Block Diagram" on page 48 for details).
To use the PROCESSOR jacks, set the CUSTOMIZE menu's
"V. PROCESSOR" parameter to "ON" (see page 38).
TV tuner
(TV or DBS tuner)
* TV : European Model
OUTPUT
VIDEO TV/DBS (Digital
OUT
Broadcasting
Satellite) : USA and
AUDIO
Canadian Models
OUT
L
R
MIC IN AC-3 RF OPTICAL COAXIAL
IN IN IN
ANALYZER LD CD
y
SIGNAL GND
L
R
IN IN IN REC OUT IN REC OUT
PHONO TUNER CD MD/DAT
IN
OUT
VCR
INPUT OUTPUT
VIDEO VIDEO
IN OUT
AUDIO AUDIO
IN OUT
L
R
DVD player
OUTPUT
VIDEO
OUT
AUDIO
OUT
L
R
*
OPTICAL OPTICAL OPTICAL OPTICAL COAXIAL OPTICAL COAXIAL
OUT IN IN IN IN IN
MD/DAT TV DVD LD
IN IN IN OUT IN
IN IN IN IN REC OUT IN
TAPE TV DVD LD VIDEO 3
ç
*
ç
ç
IN
ç
OUT
VCR
INPUT OUTPUT
VIDEO VIDEO
IN OUT
AUDIO AUDIO
IN OUT
L
R
Notes on S-VIDEO jacks
• When using the S-VIDEO jacks instead of the VIDEO jacks,
your monitor must also be connected via an S-VIDEO jack.
S-video signals are on a separate bus from the video
signals and will not be output through the VIDEO jacks.
• The S-VIDEO MONITOR OUT jack on this unit is capable of
automatically switching between wide and normal screen
formats. To determine whether your video components and/
or monitor is compatible with automatic format switching,
refer to the instructions supplied with those components.
Required cords
Audio/video cords (not supplied)
When connecting a cord, be sure to match the color-coded pins to
the appropriate jacks on the components.
Yellow (video)
White (L/audio)
Red (R/audio)
Video cord for connecting a TV monitor (not supplied)
Yellow
LD (LD/DVD) player
OUTPUT
VIDEO
OUT
AUDIO
OUT
L
R
MONITOR
CTRL A1
IN RS-232C
S-LINK
PROCESSOR
VIDEO
OUT IN OUT IN OUT IN OUT
S-VIDEO
L
AUDIO
CENTER
R
REC OUT IN REC OUT IN FRONT REAR WOOFER
VIDEO 2 VIDEO 1 PRE OUT
ç
OUT
ç
IN
Yellow (video)
White (L/audio)
Red (R/audio)
Yellow
Monitor
INPUT
VIDEO
IN
AC OUTLET
CTRL S
IN
OUT
VCR
INPUT OUTPUT
VIDEO VIDEO
IN OUT
AUDIO AUDIO
IN OUT
L
R
9 GB