Operational Overview - FIP FLS M9.07 Instruction Manual

User
AC or DC
Power
The alarm is off during normal
operation and goes ON according to
Relay setting.
If Imax > 50 mA use external Relay
RELAY WIRING DIAGRAM (FOR RELAY 1 & RELAY 2)
The alarm is OFF during normal
operation and goes ON according to
Relay settings
AC or DC
Power
HOLD AND REED CONNECTION
12-24
VDC

OPERATIONAL OVERVIEW

The M9.07 Dual-Parameter Conductivity and Flow Monitor & Transmitter
features a full graphic display and a five-button keypad for system set-up,
calibration and operation. Full graphic display has a white backlight during
standard conditions, a green backlight in case a external device control is
activated (ON/OFF, PROPORTIONAL FREQUENCY, PROPORTIONAL
PULSE and TIMED PULSE), a red backlight in case a set alarm is activated
O.V.A. , O.T.A., MIN, MAX related to conductivity measurement and MIN, MAX
WINDOW related to flow measurement, always with priority). The five push
buttons of the keypad are used to navigate display levels and modify settings.
The function of each button may change according to display level; please
refer to following table:
Connection to an User
3 N.O.
User
3 N.O.
4 COM
4 COM
Imax = 50mA
Imax = 50mA
lmax = 50mA
RELAY 2
10
11
COM
12
Alarm
17
+ HOLD
18
- HOLD
19
+ REED
20
- REED
AC or DC
Power
N.O.
3
COM 4
The alarm is ON during normal
operation and goes OFF according to
Relay settings
NO
AC or DC
NC
Power
AC or DC
Power
User
+V
Imax
External Relay
Imax
V= 12-24 VAC/VDC
lmax = 50mA Imax = 50 mA
-V
Alarm
3 N.O.
3 N.O
4 COM
4 CO
User
Imax = 50mA
Imax = 50
lmax = 50mA
N.C.
COM
N.O.
RELAY 2
10
NO
11
COM
12
NC
9